7
• The Spruce nozzle must have the Insert removed
prior to nozzle placement.
• The Birch display does not require a nozzle.
The
Redwood
nozzle uses the 3 self tapping screws to
attach over the pump housing and the Y Insert must be
installed.
Model
HP
Height
Width
8400, 2.3
2
22’
7’
3.1, 3.3
3
24’
8’
5.1, 5.3
5
26’
8’
The
Linden
nozzle (marked L inside one of the fins)
uses the 3/8” x 4” bolt.
Model
HP
Height
Width
8400, 2.3
2
18’
30’
3.1, 3.3
3
19’
35’
5.1, 5.3
5
20’
35’
7.3
7.5
24’
28’
9. On power cord lengths of 100 feet or longer with
the watertight Quick Disconnect, the power cord is
shipped separately. It should now be attached to the
stub cord by lining up the male and female halves of
the disconnect and hand tightening the blue collar. On
these cords, the Additional Strain Relief should be
attached to one of the lower float brackets as pictured.
If you receive a 3 chain strain relief (6 or 8 gauge
cord), attach one chain to each of the three lower float
brackets. If there is not Strain Relief, use the Nylon
Cable Tie provided to secure the cord to a rope to
prevent damage by the propeller. Double check the
Quick Disconnect to make sure the threaded collar has
not come loose in shipping before placing in the water.
If installing a new Quick Disconnect, please refer to
Quick Disconnect instructions. Also, at this time,
lights can be installed if purchased.
1 chain strain relief
Bottom Float Bracket
Chain
3 chain strain relief
Nozzle Options & Pattern Sizes
NOTE: Pattern sizes listed are approximate in feet.
Variations in voltage caused by regional electrical dif-
ferences or voltage drop due to long power cords may
result in reduced pattern sizes.
•
All five (or six) nozzles are included with the
package.
• The Linden, Willow, and Juniper nozzles use the
3/8” x 4” bolt.
• The Sequoia (5.1JF only) uses the 3/8” x 2.5” bolt.
• The Redwood nozzle must have the Y Insert in-
stalled prior to nozzle placement.
