2HP-5HP AERATOR MANUAL
10
ASSEMBLY INSTRUCTIONS (3-5HP)
1.
Arrange the three float sections (A) upright
so the overlap of one section aligns with the
next section and loosely push the three sec-
tions together to form a continuous ring.
2.
Position one top float bracket (D) so that the
bolt holes in the bracket align with the bolt
holes in the two adjoined float sections.
3. Insert two 9.5” hex head screws (B) through the
assembly. This may require some minor repo-
sitioning of the float sections as you push the
bolt all the way through. Do not force the bolt
through. Repeat for the remaining two joints.
4.
Turn the assembly upside down and place the bottom float brackets (G) over the bolts, the ends of
which should now be extending through the assembly.
5. Loosely install the six 3/8” lock nuts (C) on the ends of the bolts (do not tighten yet)
Float up
Float down
B
D
2
3
4
G
C
5
6.
Lift the float assembly and place it over the aerator. Use the
3/8" x 1" bolts (E) and 3/8" lock washers (F) to secure the
top and bottom float brackets to the aerator mounting ring.
Tighten with a 9/16" wrench.
6
A
E
F
Back to Contents