Karomat 66611, Instruction Manual

Page: 19 / 36

17
▪
Do not operate the product when fatigued or under the influence of alcohol or
drugs.
▪
Keep operating area clear of all persons.
▪
Do not overreach or stand on unstable support. Keep good footing and
balance at all times.
▪
Follow the maintenance instructions specified in the manual.
▪
This product must be grounded. If it has malfunction or breakdown, grounding
provides a path of least resistance for electric current to reduce the risk of
electric shock. The plug must be plugged into an appropriate outlet that is
properly installed and grounded in accordance with all local codes and
ordinances. The rating voltage (V/Hz) of the appliance has to be in
compliance with the local power supplying voltage (equipped with earth
leakage circuit breaker of 30 mA).
▪
Check with a qualified electrician or service personnel if you are in doubt as to
whether the outlet is properly grounded. Do not modify the plug provided with
the product. If it will not fit the outlet, have a proper outlet installed by a
qualified electrician. Do not use any type of adapter with this product.
▪
Use only 3-wire extension cords that have 3-prong grounding-type plugs and
3-pole cord connectors that accept the plug from the product. Use only
extension cords that are intended for outdoor use and the socket must be of
watertight construction. These extension cords are identified by a marking
"Acceptable for use with outdoor appliances; store indoors while not in use."
Use only extension cords having an electrical rating not less than the rating of
the product. Do not use damaged extension cords. Examine extension cord
before using and replace if damaged. Inadequate extension cords can be
dangerous. Do not abuse extension cord and do not yank on any cord to
disconnect. Keep cord away from heat and sharp edges. Always disconnect
the extension cord from the receptacle before disconnecting the product from
the extension cord.
Table for extensions cords:
0-10 meters: 3 x 1,5 mm² and 10-25 meters: 3 x 2,5 mm²
▪
If the supply cord is damaged, it must be replaced by a special cord or
assembly available from the manufacturer or its service agent; and should not
change the length of the cable.
▪
To reduce the risk of electrocution, don’t start and run the machine in the rain
or storm. Keep all connections dry and off the ground. Do not touch plug with
wet hands. It is strictly prohibited to let water leak into the machine.
▪
Before turning the machine on, bleed the pump by squeezing the trigger for
three minutes.
▪
When the machine is running, please maintain a constant water supply.
Without water circulation will damage the sealing rings of the machine.
▪
Make sure the water inlet hose is min. 5 meters long and undamaged. The
inlet water pressure should keep between 0,1 bar – 4 bar.
▪
Don’t start and run the machine in a place where the temperature is below
0 ºC, to prevent the machine from the freezing current.