For more information please call
+49 6203-4039-0
or send a mail to
.
FITTING THE SAFETY
GUARD
The guard is fitted with parts sup-
plied. The guard is fitted to the
front face of motor gear box sup-
port bracket by a single M6 Bolt
supplied with guard fixing plate.
OPERATING THE
MACHINE
Plug the power cable into suitable
power supply (using an extension
lead of the correct rating if neces-
sary). The use of an RCD is also
highly recommended.
Select the required speed. Do NOT
attempt to change speed while the
machine is in operation.
MAG-TEC SENSOR
The sensor detects how well the
magnet keeps the machine on the
ground. It is directly connected to
the engine.
If the sensor is illuminating
„RED“, the ground is dirty (rust,
varnish residues, chips), the
material is thinner than 6mm or
the feed rate is to high. The machi-
ne does not have a safe stand. The
engine does not start or turns off.
If the sensor is illuminating
„GREEN“, the magnetic holding
force is optimal and the use of the
machine is safe.
FITTING CUTTERS INTO
MACHINE ARBOR
Always unplug the power source
to the machine before fitting or
removing cutters or drills into the
arbour. To fit cutters loosen both
screws to permit the cutter shank
to fit fully into the arbor ensuring
the flats of the cutters are in line
with the set screws.
Start motor by pressing the green
button, at the end of drilling / cut-
ting operation press red button to
stop motor.
SECURING THE CUTTER
IN ARBOR
When cutter is fully in position
with flats lined to the screws tigh-
ten screws evenly to secure cutter
in place ready for operation.
GENERAL SAFETY INSTRUCTIONS FOR KARNASCH MAGNETIC HOLE CUTTING MACHINES
Summary of Contents for KA40
Page 7: ......
