25
4.19.2 Please remember to install the tie-down bracket kits before using the
four point webbing systems. The below photo illustrates the
installation location of tie-down bracket kits. For further information,
please contact your local dealers for assistance.
4.19.3 A four point tie-down system should tightly fasten to the lower
wheelchair frame marked with a yellow sticker as pictured.
4.19.4 An occupant restraint system using both a pelvis and
harness must also be fastened to the transport vehicle to
insure user safety. Please refer to the restraint system's instructions.
4.19.5 The attendant / transporter must double-check all fastening points
for proper connection and tightness to assure the wheelchair users
safety. The attendant / transporter must be fully cognisant of the
fastening system's usage and its weight limitations.
4.19.6 See
WARNING:
●
MVP 502 has passed the crash test under conditions. Do not use the
wheelchair as a seat in a vehicle if there is no crash tested labels of hook
mark on the chair.
4.20 Method of restraint
4.20.1 MVP502 was tested with four point webbing systems, with the back in
the upright position. Please refer to the restraint manufacturer's user
guide for further details of its operation.
4.20.2 Fitting the front restraint
4.20.2.1 Connect the straps around the wheelchair frame and caster bracket
as pictured below. The anchor point is marked with a yellow sticker.
Summary of Contents for KM-5000.2
Page 1: ...Manual Wheelchair User Manual MVP 502 Series KM 5000 2...
Page 2: ......
Page 12: ...5 Figure 2 1 Figure 2 2 Figure 2 3 Figure 2 4 Figure 2 5...
Page 47: ......
