Setting the system
Fully Setting the system
When the premises are to completely vacated you should set the full system. First, check that the premises
are physically secure - are all windows shut, and all external doors locked?
Key in a normal user code at the keypad nearest the final exit door and press the ENTER key.
1. Set System?
The exit period will start and the inside sounder will produce the exit sound - a pip-pip-pip sound. The
display identifies the program that you are setting.
Program A Set
PROGRAM A
The bottom line on the display may have been edited during installation to read a different message, for
example it may read FULL SYSTEM.
You must now vacate the premises by the exit route described in the SIS. The length of time that you have
to vacate the premises depends on the exit mode that has been programmed. Check your SIS to find out the
exit mode of programme A.
Part-Set the System
A part-set allows detection points in part of the protected premises to be set (turned on), while those in other
areas are not set. In a domestic installation it is usual for a part-set to be programmed for use at night time.
This would allow the detection points around the perimeter of the house (doors, windows, etc), and all
downstairs detectors to be enabled, while detectors in the bedrooms and on the stairs are disabled.
has 2 different part-set programs called B and C. Check your SIS to see if these programs have
been enabled. If they have not been enabled then you will not be able to use them. If a part-set has been
enabled you can part-set your system by doing the following: Enter your code at a keypad and press the
ENTER key. The system will begin to perform a full-set (setting programme A).
Program A Set
PROGRAM A
Within 5 seconds of entering your code (while the red FUNCTION indicator is still on) you must
press either the SET B or SET C key to select one of the part-set programmes and press the
ENTER key. The display will acknowledge this by displaying name of the program being set.
Program B Set
PROGRAM B
The bottom line on the display may have been edited during installation to read a different message, for
example it may read NIGHT TIME. Leave the protected area by the exit route appropriate for that part-set.
