Karibu 80580, Building Instructions

Page: 54 / 213

WORLD OF WELLNESS
EN
Instructions for installation and use p. 7/22
3. Product description
3.1. Scope of delivery
● Single-component sauna control unit
● Heater sensor with integrated safety temperature limiter and connection terminal
● Bench sensor with connection terminal
● Power supply cable
● Installation accessories
3.2. Product functions
The Modern Bio Plug‘n‘Play sauna control unit is used to control and regulate
combination sauna heaters with a heating output of up to 3.6 kW and an evapo-
rator output of up to 1.2 kW in the temperature range spanning 40°C to 125°C
and a humidity intensity from 0 to 100%.
The sauna control unit functions according to a two-sensor system. The excess
temperature fuse is located in the heater sensor housing. Should the sauna
heater continue heating after reaching the preferred temperature due to a defect,
the excess temperature fuse switches the sauna heater off at a temperature of
approx. 139°C.
Dry heat is provided in sauna mode. The temperature in the cabin is high (80 to
100°C). The humidity level is low and does not exceed 10%. If the sauna cabin
temperature is lower than the set temperature, the sauna control unit switches
on the sauna heater. The sauna heater heats up. If the sauna cabin temperature
exceeds the set temperature, the sauna control unit switches off the sauna heater.
The sauna heater will not heat up again until the sauna cabin temperature falls
below the set temperature.