Instructions – 90001
For Technical Support Call: 800-343-7486, Monday-Friday, 7AM - 4 PM (PST)
Page 9
Step 1A – Install Feet – Standard Installation:
Position a footplate on the bedrail, as far forward as possible, with the inside of the bed is against the
downward flange on the foot.
Position a second footplate on the bedrail, with
the foot U-bracket saddle located near the rear
stake pocket.
If there are covers over the stake pockets, remove the covers. Some stake pockets are covered with solid
plastic. Bed rails should be cut to access.
Determine which pre-drilled hole falls over the stake pocket. For most trucks, the feet have been
designed to have at least one hole that will be near center of the stake pocket.
If the none of the pre-drilled holes fall over the stake pocket, mark and drill a 13/32” hole in the foot plate
that is approximately over the center of the stake pocket.
Front Foot Stake Pocket:
Put 3/8” x 2-1/2” button head screw with
3/8” lock washer and 3/8” washer through
footplate and start T-nut as shown.
Maneuver the T-nut inside the stake pocket, push
the footplate forward against the bulkhead, and
then snug tighten the T-nut up against the
underside of the truck bed rail. Be sure inside of
the bed is against downward flange on the foot.
LOOSELY tighten T-nut inside stake pocket.
Hole location example only.
Actual hole depends on
actual stake pocket location.
3/8” X 2-1/2”
Button Head Screw
