Instructions
–
8006A-Rev 1
For Technical Support Call: 800-343-7486 Monday-Friday 7AM - 4 PM (PST)
Page 12
Step 1D
–
Camper shell
•
Find desired ladder location on top of camper shell.
**This step is easier if the rack is completely assembled**
•
Place feet on top of camper shell in desired location.
•
Mark through the slots in the feet onto the top of the camper shell.
•
Ensure the desired location is safe to drill.
•
Drill the center of each slot using a 5/16”
drill.
•
Place sealant around the exposed holes in
the roof in between the rubber pieces to
prevent water from leaking into the cargo
area.
•
Place the two-hole rubber pad on top of
drilled holes. Be sure to put sealant around
the holes and rubber pad.
•
Place the foot on top of the rubber pad.
•
Bolt through the foot, the rubber pad and
the camper shell using two M8 x 40mm hex
heads and two M8 flat washers.
•
From the inside of the camper shell, place
the three-hole rubber pad over the
previously installed hex heads and up
against the inner side of the camper shell.
Put some sealant around the holes and
rubber pad.
•
Place the metal plate against the rubber
pad, followed by two M8 flat washers and
two M8 nyloc nuts.
•
Repeat on both ends of the cross bar and
on both cross bars.
•
Snug tighten, but allow movement.
