Karel DSS25, Technical Reference And User'S Manual, Page: 13 / 16

DSS25–28 Direct Station Select Module
6
KEY PROGRAMMING
There are 28 programmable keys and the programming of DSS25-28 module is made
directly over the ST digital telephone set from Telephone Settings> Key Programming.
Keys will be activated after exiting from programming mode.
These keys can not be deleted one by one however another feature or extention or line
can be assigned to those keys without any error message. All assignments to keys can
be deleted from Telephone Settings> Key Programming > Auto Setting > Clear all.
Extension
You can reach an extension you call frequently through a single key by programming
her/his number on that key.
♦
Press Key: Press the key which is wanted to be programmed.
♦
Extension No: Then the “Extension No=”menu comes to view. In this menu, the
display cursor enables data entry. After the user enters the extension number by
using the numeric keypad, s/he confirms the extension number s/he has entered
by pressing the “Accept” key. The user can enter an extension number with at
most 8 digits, when a wrong number is entered, system will give an error.
If entered number is programmed to another key before, the previous key will be
deleted and new key will be programmed for that number.
An extension number can be assigned to a single key only. After the programming
mode is exited and those keys are pressed, the extension that has been stored on the
key is directly called. In addition to the calling function, status of the extension, which
has been programmed as the first function of the programmable keys can be viewed by
the LED next to it.
Line
It enables you to program a specific line number on a key. By pressing that key, you
can access the line that has been programmed on the key and make a call (provided
that it is vacant) and you can access that number by a single key.
♦
Press Key: Press the key which is wanted to be programmed
♦
Line No: If a determined line number is entered and confirmed, then that line
number will have been assigned to that key.
The lines, which exist on the system, should be entered. These numbers can be 8 digit
at most. A line access code can be assigned to a single key only. After the
programming mode has been exited, upon pressing those keys, it is possible to access
the programmed line, without pressing 9.
Status of the line, which has been programmed as the first function of the key can be
viewed by the LED next to it.