37
/
6.
Hold the button (IN/OUT) on the control panel for about 1-5
seconds, while the non- insulated section of the sensor cable
is in contact with water.
7.
Lamp A will show RED when the sensor is connected
correctly.
8.
A maximum of 12 wireless sensors can be connected by
following the same procedure.
9.
If more than 12 wireless sensors are connected, the first
sensor connected will disconnect.
10.
Disconnect Wireless Sensor (s). If one or more sensors must
be disconnected, the wireless sensor cable must be in
contact with water, and the IN/OUT button held for 8-12
seconds. Lamp: A red light will come on upon confirmed
disconnection. If you have unplugged a sensor, you must
reset the sensor.
Connection of remote control/door switch.
1.
Hold down the ON button while pressing the IN/OUT button on
the control unit for 1-5 seconds.
2.
The controller delivers a beep signal and a red light illuminates
in the lamp.
3.
The switch is now ready for use.
4.
If you wish to, mount the holder, for example on the outside
door - Push the switch (gray) in the holder for approx. 5
seconds then release the switch.
5.
Now you can mount the holder on the wall with two screws.
Replace the switch in the holder.
