8.780-016.0
• Xpert-HD/DD • Rev. 10/09
OPERATOR’S MANUAL
PRESSURE WASHER
8
Step 1: Attach the handle to the
frame of the pressure washer.
Note:
It may be necessary to move the
handle supports from side to side
in order to align the handle so it will
slide over the frame supports.
Step 2: Insert the carriage bolt
through the holes from the front of
the unit and attach a knob from the
back of the machine. Tighten Knobs
with your hands.
Step 3: Attach the hose hanger
and insert screw from outside, place
washer through screw from inside
and insert nut from inside as well.
Tighten nut.
Step 6: Attach the high pressure
hose to the spray gun using teflon
tape on hose threads.
Step 9: Release the coupler collar
and push the nozzle until the collar
clicks. Pull the nozzle to make sure
it is seated properly.
Step 10: Connect the high pres-
sure hose to the discharge nipple.
Push coupler collar forward until
secure.
Step 7: Attach wand to spray gun/
wand. Tighten both.
Step 8: Pull spring-loaded collar
of the wand coupler back to insert
your choice of pressure nozzle.
Step 11: Connect garden hose to
the cold water source.
ASSembly INStrUCtIoNS
Step 12: Check inlets filters,
remove debris, then connect the
garden hose to pump water inlet.
CAUTION: Do not run the pump
without water or pump damage
will result.
Alignment
Holes
Handle
frame
Assy.
bolt
Knob
Washer
Hose
Hanger
Safety
latch
Spray
Gun
High
pressure Hose
Wand
Spray
Gun
Wand
Coupler
pressure
Nozzle
pressure
Nozzle
Wand
Coupler
Coupler
Collar
discharge
Nipple
High
pressure
Hose
Cold
Water
Source
Garden
Hose
pump
Water Inlet
Garden
Hose
Coupler Collar
Nut
Screw
Step 4: Attach the gun storage
bracket and insert bolts from the
outside, place washers through
bolts from inside and insert nuts
from inside as well. Tighten nuts.
Washers
bolts
Nuts
Gun
Storage
bracket
Step 5: Attach the plastic plate
from the top aligned to the four
holes placed on top of the handle
and insert the rivets through holes
of plastic plate.
plastic
plate
rivets
