![background image](http://html1.mh-extra.com/html/karcher/winner-150/winner-150_original-operating-instructions_655675010.webp)
10
English
The scope of delivery of your appliance is illus-
trated on the packaging. Check the contents of
the appliance for completeness when unpack-
ing.
In the event of missing accessories or any trans-
port damage, please contact your dealer.
Illustrations on Page 2
1
High pressure connection
2
Detergent suction hose (with filter)
3
Appliance switch "0/OFF“/ „I/ON“
4
Storage for high-pressure hose
5
Carrying handle
6
Transport handle, adjustable height
7
Storage for trigger gun
8
Mains cable with mains plug
9
Connection for water supply with filter
10 Bearing wheel
11 Coupling element for water connection
12 Trigger gun
13 High pressure hose
14 Spray lance with high pressure nozzle
Illustration
Î
Insert the transport wheels and lock them.
According to the applicable regulations,
the appliance must never be used on the
drinking water net without a system sep-
arator. Use a suitable system separator as per
EN 12729 type BA. Water flowing through a sys-
tem separator is considered non-drinkable.
Observe regulations of water supplier.
For connection values, see type plate/technical
data.
Î
Use a fibre-reinforced water hose (not in-
cluded) with a standard coupling. (Minimum
diameter 1/2 inch (13 mm), minimum length
7.5 m).
Î
Screw the coupling unit (supplied) to the wa-
ter connection on the appliance.
Î
Push the water supply hose onto the cou-
pling unit, then connect it to the water supply.
Caution
Dry runs lasting longer than two minutes lead to
damages to the high pressure pump. If the appli-
ance does not build up pressure within two min-
utes, switch it off and proceed as instructed in
the Chapter "Help with faults".
In case of impurities in the supply water, a 3/4"
fine water filter must be used.
Î
Connect the high pressure hose to the high
pressure connection of the appliance.
Î
Push the spray lance into the trigger gun and
fasten it by turning it through 90°.
Î
Completely open the water tap.
Î
Insert the mains plug into the socket.
Î
Turn on the appliance “I/ON”.
몇
Danger
The trigger gun is subjected to a recoil force
when the water jet is discharged. Make sure that
you have a firm footing and are also holding the
trigger gun and spray lance firmly.
Î
Unlock the lever on the trigger gun.
Î
Pull on the lever of the trigger gun; the device
will switch on.
Note:
Release the lever of the trigger gun; the
device will switch off again. High pressure re-
mains in the system.
For normal cleaning tasks.
Not suitable for use with detergents.
Î
Pull detergent suction hose as far as is re-
quired out of the housing.
Î
Suspend end of detergent suction hose in a
container filled with detergent.
Î
Detach spray lance from the trigger gun.
Work only with the trigger gun.
Note:
This will mix the detergent with the wa-
ter stream.
Î
Spray the detergent sparingly on the dry sur-
face and allow it to react, but not to dry.
Î
Spray off loosened dirt with the high-pres-
sure jet.
Operation
Description of the Appliance
Before Startup
Water supply
Water supply from mains
Start up
Operation
Spray lance with high pressure nozzle
Working with detergent
Recommended cleaning method