Kärcher Telescopic Lance, Manual

Page: 9 / 96

– 2
The telescopic spray lance can be used
with all Kärcher Home & Garden high-pres-
sure cleaners of the K2 to K7 classes.
It is not suitable for commercial use.
Only use original accessories and spare
parts, they ensure the safe and trouble-free
operation of the device.
For information about accessories and
spare parts, please visit www.kaerch-
er.com.
The following parts must be installed prior
to operation: High pressure hose, kink pro-
tection sleeve, intake for spray lance, carry-
ing belt and spray lance.
Select the nozzle to match the high pres-
sure cleaner used.
K 2, K 3, K 4, K 5 : Use brown high pres-
sure nozzle
K 6, K 7 : Use white high pressure nozzle
(already installed)
Illustration
 Remove the clamp for the nozzle
mount.
First, loosen the clamp from below with
a small screwdriver.
 Pull out the unneeded high pressure
nozzle.
 Select the high pressure nozzle needed
to match the high pressure cleaner
used and press them in.
 Insert the clamp and secure the high
pressure nozzle.
Illustration
 Loosen the fastening nut and extend
the thin end of the pipe by about 30 cm.
Illustration
 Insert the kink protection sleeve onto
the end of the lance.
Illustration
 Insert the high pressure hose from the
bottom through the kink protection
sleeve and the lance until the high pres-
sure connection becomes visible at the
end of the lance (approx. 15 cm).
Illustration
 Pull the clamp out of the intake.
 Hold on to the high pressure hose and
slide the intake onto the high pressure
connection until it locks into place.
 Slide the intake all the way onto the
lance and turn it until the two holes are
aligned with the bores in the lance; then
press the clamp in and secure it.
Illustration
Note : Disentangle the high pressure hose
and install it.
 Pull out the clamp for the high pressure
hose from the trigger gun.
 Connect high pressure hose to trigger
gun.
 Push the clamp in until it locks. Check
the secure connection by pulling on the
high-pressure hose.
Illustration
 Push the spray lance all the way into the
adapter and fasten it by turning it by
90°.
Illustration
 Hook the carrying belt into the intakes.
General information
Proper use
Spare parts
Preparing the Appliance
Mount the high pressure nozzle
onto the spray lance
Install high pressure hose, kink
protection sleeve and intake for the
spray lance
Mount the high-pressure hose on
the hand spray gun
Mount the spray lance
Mount the carrying belt
9 EN