Kärcher SE 6.100, Manual

Page: 20 / 28

–
2
0
Illustration
 Turn both releases in the direction of the arrow, re-
move the appliance head and take accessories out
of the container.
Illustration
 Mount wheels and steering rollers.
Illustration
 Attach the accessories holder.
 Wet cleaning
(see chapter "Fill wet cleaning/fresh water reser-
voir")
 Dry vacuum cleaning
(see chapter "Dry vacuuming")
 Vacuuming up moist dirt/water
(see chapter "Vacuuming up moist dirt/water")
Illustration
 Insert and lock the appliance head.
Illustration
 Attach the suction hose and the spray hose to the
connectors on the appliance.
Note:
Press the suction hose tightly into the connection
so that it locks into place.
Illustration
 Connect the spray/suction pipes and attach to the
handle. Center the locking lever when attaching it,
turn clockwise to lock.
 Attach the washing nozzle to the spray suction
pipes and secure it by means of the locking lever.
The appliance is now prepared for wet cleaning.
ATTENTION
Check the object to be cleaned prior to using the appli-
ance in an inconspicuous place for colour fastness and
water resistance.
Do not clean water-sensitive floor coverings such as
wood floors (the moisture could penetrate and damage
the floor).
Notes:
Warm water (max. 50°C) will increase the cleaning ef-
fect.
Only use detergent pump while operating. Avoid dry
runs as well as unnecessary pressure buildup (dynamic
pressure) as much as possible.
If there is a risk of overheating, the thermal protection
switch shuts off the detergent pump. After cooling down
(20 - 30 min), the pump is ready for use again.
Illustration
You can remove the water reservoir to fill it.
Add 100 - 200 ml of the carpet cleaner RM 519 (volume
depends on degree of soiling) into the fresh water tank,
top up with tap water, do not overfill (observe MAX
marking).
 Use washing nozzle for carpet cleaning.
 Work without hard floor attachment.
Please only use the carpet cleaner RM 519.
Do not clean laminate or parquet floors!
 Use washing nozzle for carpet cleaning.
 Slide the hard floor attachment onto the washing
nozzle from the side.
The squeegee points towards the front, the brush
strip towards the back.
 Use washing nozzle for upholstery cleaning.
Illustration
 Insert the mains plug into the socket.
 Press the switch for vacuuming, suction turbine is
running.
Illustration
 Close fully the surrounding air separator at the han-
dle.
Illustration
 Press the switch for spraying, the detergent pump
is ready.
Illustration
 Use the lever on the spray handle to spray on de-
tergent solution.
Illustration
 For continuous spray, the spray lever can be
locked; for this, activate the spray lever and pull the
locking key toward the rear.
 Run across the surface to be cleaned in overlap-
ping paths. Pull the nozzle backwards (do not
push).
Operation
Before Startup
Start up
Wet cleaning
carpets/hard floors/upholstery
Fill the fresh water reservoir
Wet cleaning of carpeted floors
Wet cleaning of hard floors
Wet cleaning of upholstery
Start working