Kärcher SC 3, User Manual

Page: 6 / 22

6 English
plate must match the voltage of
the power source.
 Do not di-
rect the steam jet directly onto
equipment containing electrical
components, e.g. the interior
space of ovens.
 Do not fill the
devices with removable water
reservoir directly via the water
connection while they are con-
nected to the mains power. Use
a receptacle for filling.
 Do not
use the d
evice
in swimming
pools which contain water. 
The mains plug and extension
cable connection must not be in
water.
몇
WARNING  Only
connect the device to an
electrical connection which has
been set up by a qualified
electrician as per IEC
60364-1.
 Only operate the device in wet
rooms, e.g. bath-room,
connected to sockets with
upstream residual current de-
vice.
 Check the power supply
cable with mains plug for dam-
age before operation each time.
Do not put the device into oper-
ation with a damaged power
supply cable. Have a damaged
power supply cable replaced
im-mediately by the authorised
customer service / qualified
electrician.
 Do not damage
the power supply and extension
cable by running over it, crush-
ing or yanking it or similar. Pro-
tect the power supply cable from
heat, oil and sharp edges.
 Un-
suitable electrical extension ca-
bles can be dangerous. Only
use electrical extension cables
with a splash guard and a diam-
eter of at least 3x1 mm
2
.  Only
replace couplings on the power
supply or extension cable with
those with the same splash
guard and the same mechanical
strength.
 Clean tiled walls with
sockets carefully.
몇
CAUTION  In case of longer
breaks in operation and after
use, switch off the device at the
main switch / device switch and
pull the mains plug.
Operation

DANGER  Operation in ex-
plosive atmospheres is prohibit-
ed.
 When using the device in
hazard zones (e.g. service sta-
tions), adhere to the respective
safety regulations.
몇
WARNING  Risk of scald-
ing. Never touch the steam jet
with your hand from a close dis-
tance, and do not direct it at peo-
ple or animals.
 Risk of
scalding from high water output
if you tilt the due to more than
30° to the side when using it.
Applies to SC 1 devices only
 Risk of scalding on the hot
steam boiler. Allow the steam
boiler to cool down before filling
it with water.
Does not apply to SC 3 devices