Kärcher Puzzi 30/4, Original Instructions Manual

Page: 16 / 236

– 4
 If the wastewater container is full,
switch off the appliance. In order to do
so, set the rotary switch to 0/OFF.
 Unlock the bonnet, swivel it upwards
and snap it in place at the locking devic-
es.
 Remove the wastewater container from
the appliance and drain it.
 Switch off the appliance, in order to do
so, set the rotary switch to 0/OFF.
 Shortly activate the lever on bender to
decrease the pressure.
 Separate bender from the spray/suction
hose.
 Remove the lid of the fresh water tank.
 Insert the suction hose into the fresh
water reservoir.
 Set rotary switch to vacuuming. Suction
turbine is switched on.
 Empty the fresh water reservoir and
switch the appliance off.
 Empty the wastewater reservoir.
 Connect the manifold (with suction pipe
and nozzle) to the suction hose.
 Connect the coupling of the spray hose
with the manifold and snap in place.
 Fill approx. 2 litres of fresh water into
the fresh water reservoir.
Do not add any detergents.
 Set rotary switch to spraying. Spray
pump is switched on.
 Hold floor nozzle over a drain.
 Activate lever on bender and flush the
appliance for appr. 1 to 2 minutes.
 Switch off the appliance, in order to do
so, set the rotary switch to 0/OFF.
 Flush appliance.
 Dismantle the bonnet, unlock and re-
move the filter casing. Clean the bonnet
under running water.
 Empty the wastewater container and
clean it under running water.
 Empty the fresh water reservoir.
 Clean the outside of the appliance with
a damp cloth.
 Remove all water from the appliance
prior to longer periods of non-use to
avoid offensive odours.
 Allow appliance to dry thoroughly: Un-
lock the bonnet, swivel it upwards and
snap it in place at the locking devices.
Remove the lid of the fresh water tank.
Illustration
 Place the floor nozzle in the tray and
snap the suction pipe into the holder.
 Store the suction hose and the mains
cable as shown in the illustration.
 Place the appliance in a dry room and
secure it from unauthorized use.
 Spray and suction off detergent solution
in one work cycle.
Note: Repeated suctioning without spray-
ing will shorten the drying time.
 Apply detergent solution with suction
turbine turned off and soak for 10 to 15
minutes.
 Clean the surface just like with normal
soiling.
 In order to further improve the cleaning
result, the surface can be recleaned us-
ing clear, warm water.
Empty wastewater container
Empty the fresh water reservoir
Flush appliance
After each operation
Storing the Appliance
Cleaning methods
Normal soiling
Strong soiling or stains
16 EN