Kärcher Puzzi 30/4, Original Instructions Manual

Page: 15 / 236

– 3
몇
Warning
Health risk, risk of damage. Observe all in-
dications on the detergent used.
 Mix fresh water and detergent in a clean
container (use the concentration rec-
ommended for the detergent).
Dissolve detergent in the water.
Note: Warm water (max. 50°C) will in-
crease the cleaning effect. Verify the tem-
perature resistance of the surface to be
cleaned.
Note: For considerate treatment of the en-
vironment use detergent economically.
 Remove the lid of the fresh water tank.
 Fill the cleaning solution into the fresh
water tank up to the 1/1 marking (ap-
prox. 30 litres) of the filling level indica-
tor.
 Reinstall the lid of the fresh water tank.
 Push the unlocking device of the floor
nozzle on one side.
 Swivel out and remove the carpet
adapter.
 Insert a new carpet adapter and snap
the locking device in place.
Note: There is an additional socket to con-
nect electrical accessory devices.

Danger
Risk of injury and damage! The socket is
only intended for the direct connection of
the additional brush washing head P 30/1
to the Puzzi 30/4. Any other use of the
socket is not permitted.
 Loosen the fastening screws of the
pushing handle and adjust the pushing
handle.
 Plug in the main plug.
 Set rotary switch to spraying. Spray
pump is switched on.
 Set rotary switch to vacuuming. Suction
turbine is switched on.
 Set rotary switch to spraying/vacuum-
ing. Spray pump and suction turbine are
switched on.
Caution
Risk of damage. Check the object to be
cleaned prior to using the appliance in an
inconspicuous place for colour fastness
and water resistance.
 Operate the lever on the manifold in or-
der to spray the cleaning solution.
 Run across the surface to be cleaned in
overlapping paths. Pull the nozzle back-
wards (do not push).
Note: The suction air flow is interrupted by
the float if the wastewater container is full.
 Switch off the appliance, in order to do
so, set the rotary switch to 0/OFF.
 Pull out the mains plug.
Illustration
 Unlock bonnet, in order to do so, fold up
the carrying handle of the wastewater
container by 90° Bonnet can be
opened.
 Unlock the bonnet.
Illustration
 Swivel the bonnet backwards by 180°
and pull it out.
Note: Be careful when inserting the
bonnet, so that the guide pins do not get
damaged.
Prepare cleaning solution
Fill up fresh water reservoir
Replacing the carpet adapter
Operation
Working with attachments
Fold the push handle in/out
Turning on the Appliance
Cleaning
Turn off the appliance
Unlocking the bonnet
Dismantling the bonnet
15 EN