Kärcher NT 35/1 Tact Te H, Original Instructions Manual

Page: 21 / 294

– 4
Illustration

Properly insert the connection socket in
the suction connection.

Push in the connection socket until it
locks into place.

Turn the suction connection with the
connection socket to the right to close it
tightly.
Note: The accurate fit is ensured by means
of a "bayonet connection".

Release and remove the suction head.
Illustration

Pull over the safety filter sack.
Illustration

Pull out the safety sheet.

Close the safety filter sack using the
self-adhesive flap.

Pull the safety filter sack towards the
rear.
Illustration

Close tightly the opening of the suction
connection of the safety filter sack using
the closing lid.
Illustration

Securely close the safety filter bag with
the attached cable tie.

Remove the safety filter bag.

Wipe the inside of the container using a
damp cloth.

Dispose of the safety filter bag in a dust-
tight bag according to the statutory pro-
visions.

Insert and lock the suction head.
–
To suck wet dirt, always remove the
safety filter bag.
몇
Warning
The flat pleated filter must always be in
place while vacuuming.
–
If wet dirt is vacuumed with the uphol-
stery or crevice nozzle, or if water is
sucked up from a container, it is recom-
mended to deactivate the "automatic fil-
ter cleaning" function.
–
If the maximum liquid level is reached
the appliance will turn off automatically.
–
In case of non-conductive liquids
(such as emulsion drilling fluids,
oils, and greases) the appliance is
not turned off when the container is
full. The filling level must be continu-
ously monitored and the container
must be emptied in time.
–
After the wet vacuuming: Clean the flat
folded filter with the filter cleaning.
Clean the electrodes with a brush.
Clean the container with a damp rag
and dry it.
Illustration
The suction hose is equipped with a clip
system. All C-35/C-DN-35 accessories can
be connected.

Plug in the main plug.

Switch on the appliance at the main
switch.

Set the suction output (min - max) at the
rotary switch.

Danger
Risk of injury and damage! The socket out-
let is only for the connection of power tools
to the vacuum cleaner. Any other use of the
socket outlet is not permitted.

Connect the mains plug of the electric
power tool to the vacuum cleaner.

Switch on the appliance at the main
switch.
Indicator lamp is on; vacuum cleaner is in
the standby mode.
Note:
The vacuum cleaner is turned on and
off automatically with the electric power
tool.
Close the suction connection
Removing the safety filter sack
General
Clip connection
Operation
Turning on the Appliance
Adjust the suction output
Working with electrical power tools
20 EN