Kärcher KM 85/50 W G Adv, Manual

Page: 22 / 312

-
9
If the sweeping results degrade due to the
wear of the sealing strips, the sealing strips
must be readjusted or replaced.
Note: If the appliance is tilted backwards
onto the push handle, the fuel tank must not
be filled more than halfway.
 KM 85/50 W G Adv
Turn the push handle lock counter-
clockwise; lock is unlocked.
 Close fuel cock.
 Remove the waste container.
 Push appliance to the back onto the
push handle.
 Front sealing strip
 Loosen the fastening screws of the
sealing strip.

Readjust the sealing strips pushing
them downward into the slot.
 Tighten the fastening screws of the
sealing strip.
 Prepare the appliance and move it a
small distance forwards.

Set the distance between the sealing
strip and the floor so that the bottom
edge trails behind at a distance of be-
tween 10 and 15 mm.
Note: If the setting range is not sufficient,
the sealing strip is worn off and should be
replaced.
 Rear sealing strip
 Remove the waste container.
 Loosen the fastening screws of the
sealing strip.
 Replace the sealing strip.
 Tighten the fastening of the sealing
strip.
 Side sealing strips
 Loosen the fastening screws of the
sealing strip.
 Replace the sealing strip.
 Screw on new sealing strip without fully
tightening it.
 To set the floor clearance, insert a
sheet with a thickness of between 1 and
2 mm under the sealing strip.

Adjust sealing strip.
 Tighten the fastening of the sealing
strip.
몇 WARNING
Empty waste container before replacing
dust filter. Wear a dust mask when working
around the dust filter. Observe safety regu-
lations on the handling of fine particulate
material.
 Lock parking brake.
 Remove the waste container.
 Remove the securing splint of the vibra-
tor bar.
 Pull out the bar.
 Unscrew the screws.
 Remove the tin frame.
 Replace the dust filter.
Note: Make sure when installing the new
filter that the fins are not damaged.
Adjusting and replacing sealing strips
Replacing dust filter
22 EN