Operating Instructions
KM 85/50 W Comfort / KM 85/50 W Classic / KM 85/50 W P Comfort / KM 85/50 W P Classic
English
28
Replacing the fuse
!
Remove cover using a
screwdriver
!
Replacing the fuse
!
Replace cover
Note:
The automatic cutout must be
depressed.
(Applies only to
KM 85/50 W Comfort and
KM 85/50 W P Comfort)
Check the sweep roller
!
Lock the hand brake
!
Remove the swept material
container
!
Remove tapes and string from
the sweep roller
!
Insert the swept material
container
Replace the sweep roller
Replacement is necessary when the
main brush cannot be readjusted
any more and sweeping efficiency
obviously deteriorates due to worn
bristles.
!
Release push handle lock by
turning it counterclockwise
(Applies only to
KM 85/50 W Comfort and
KM 85/50 W P Comfort)
Danger!
!
Remove the debris container
prior to tilting the sweeper (see
the section on "Emptying the
debris container"). For
KM 85/50 W Comfort and
KM 85/50 W P Comfort it is
additionally necessary to release
the push handle lock!
!
Tilt the machine back
!
Unscrew the left and right
fastening screws
!
Remove main brush downwards
!
Pay attention to the position of
the bristle set when installing the
new main brush!
Note:
The bristle pile is structured to an
arrow which must point towards the
rear wheels.
!
Insert new main brush and fasten
—
Make sure that the position of the
rectangular clamping plate is
proper!
—
It must overlap the main brush at
the top and bottom
!
Insert the swept material
container
Checking and adjusting
sweeping area of the
sweeping roller
!
Cover a level surface evenly with
dust
!
Raise the sweeping machine on
the front and put it on the
prepared surface
!
Lock the hand brake
!
Run the main brush for
approx. 15-30 s
!
Raise the sweeping machine on
the front and move it to the side
The form of the sweeping pattern
forms a regular rectangle, that is
between 30 - 40 mm wide.
Note:
If the sweeping pattern is uneven it
can be corrected by readjusting the
sweeping pattern width!