Kärcher KM 85/50 W Bp, Manual

Page: 23 / 27

-
9
Î
Loosen counter-nut.
Î
Adjust the adjustment screw.
Î
Tighten the counter-nut.
–
Adjustment is necessary if the bulk
waste flap cannot be raised wide
enough.
–
The Bowden cable needs to be re-
leased a little if the sweeper results be-
come poorer, for e.g. due to the wearing
of the front lip.
Î
Loosen counter-nut.
Î
Adjust the adjustment screw.
Î
Tighten the counter-nut.
If the sweeping results degrade due to the
wear of the sealing strips, the sealing strips
must be readjusted or replaced.
Î
KM 85/50 W Bp Adv
KM 85/50 W Bp Pack Adv
Turn the push handle lock counter-
clockwise; lock is unlocked.
Î
Remove the waste container.
Î
Push appliance to the back onto the
push handle.
„
Front sealing strip
Î
Loosen the fastening screws of the
sealing strip.
Î
Readjust the sealing strips pushing
them downward into the slot.
Î
Tighten the fastening screws of the
sealing strip.
Î
Prepare the appliance and move it a
small distance forwards.
Î
Set the distance between the sealing
strip and the floor so that the bottom
edge trails behind at a distance of be-
tween 10 and 15 mm.
Note: If the setting range is not sufficient,
the sealing strip is worn off and should be
replaced.
„
Rear sealing strip
Î
Remove the waste container.
Î
Loosen the fastening screws of the
sealing strip.
Î
Replace the sealing strip.
Î
Tighten the fastening of the sealing
strip.
„
Side sealing strips
Î
Loosen the fastening screws of the
sealing strip.
Î
Replace the sealing strip.
Î
Screw on new sealing strip without fully
tightening it.
Î
To set the floor clearance, insert a
sheet with a thickness of between 1 and
2 mm under the sealing strip.
Î
Adjust sealing strip.
Î
Tighten the fastening of the sealing
strip.
!
WARNING
Empty waste container before replacing
dust filter. Wear a dust mask when working
around the dust filter. Observe safety regu-
lations on the handling of fine particulate
material.
Î
Lock parking brake.
Î
Remove the waste container.
Î
Remove the securing splint of the vibra-
tor bar.
Î
Pull out the bar.
Î
Loosen screws.
Î
Remove the tin frame.
Î
Replace the dust filter.
Note: Make sure when installing the new
filter that the fins are not damaged.
Adjust the raising of the bulk waste flap
Adjusting and replacing sealing strips
Replacing dust filter
(1