Operating Instructions
KM 85/50 W B Comfort / KM 85/50 W B Classic
English
28
Danger!
For all work in this area care must
be taken to ensure that the exhaust
pipe has cooled down.
Burns can be caused by touching it.
Setting sweeping pattern width of
KM 85/50 W B Comfort
Note:
The bowden cable must be
readjusted if the sweeping pattern is
insufficient and the bowden cable is
tight when the main brush is in its
lowered position.
Set sweeping pattern at the
bowden cable
Check the sweep mirror again
Setting the sweeping pattern
width of KM 85/50 W B Classic
Turn the rotary knob (1)
—
Turning it counterclockwise: the
sweeping pattern is increased
—
Turning it clockwise: the
sweeping pattern is reduced
Check the sweep mirror again
Replacing the side broom
Replacing it is necessary when the
sweeping effect visibly deteriorates
due to wear of the bristles.
Warning!
Close fuel shut-off valve prior to
starting assembly work.
Close the fuel feed line
—
Rotary knob is transverse to fuel
hose
Unlock push handle lock by
turning it anticlockwise (Applies
only to KM 85/50 W B Comfort)
Danger!
—
The permissible maximum tank
filling when the sweeper is tilted
back onto the push handle is half!
Remove the debris container
prior to tilting the sweeper (see
the section on "Emptying the
debris container"). For
KM 85/50 W B Comfort it is in
addition necessary to unlock the
push handle lock!
Tilt the machine back
Undo screws (3 pieces) at
underside of the side brush
Take-off the side broom
Slide new side brush onto shaft
Fasten with screws (3 pieces)
Tilt the machine back upright
Adjusting lowering of side
brush
Readjustment is necessary when
the sweeping efficiency of the side
brush deteriorates due to worn
bristles.
Unscrew the locking nut
Readjust the setscrew
Tighten the locking nut
Adjusting raising of coarse-
dirt flap
Readjustment is necessary when it
is not posible to sufficiently raise or
lower the coarse-dirt flap.
Unscrew the locking nut
Readjust the setscrew
Tighten the locking nut
