Operating Instructions
KM 85/50 W B Comfort / KM 85/50 W B Classic
English
27
Check the sweep roller
Lock the hand brake
Remove the swept material
container
Remove tapes and string from
the sweep roller
Insert the swept material
container
Replace the sweep roller
Replacement is necessary when the
main brush cannot be readjusted
any more and sweeping efficiency
obviously deteriorates due to worn
bristles.
Warning!
Close fuel shut-off valve prior to
starting.
Close the fuel feed line
—
Rotary knob is transverse to fuel
hose
Unlock push handle lock by
turning it anticlockwise (Applies
only to KM 85/50 W B Comfort)
Danger!
—
The permissible maximum tank
filling when the sweeper is tilted
back onto the push handle is half!
Remove the debris container
prior to tilting the sweeper (see
the section on "Emptying the
debris container"). For
KM 85/50 W B Comfort it is in
addition necessary to unlock the
push handle lock!
Tilt the machine back
Unscrew the left and right
fastening screws
Remove main brush downwards
Pay attention to the position of
the bristle set when installing the
new main brush!
Note:
The bristle pile is structured to an
arrow which must point towards the
rear wheels.
Insert new main brush and fasten
—
Make sure that the position of the
rectangular clamping plate is
proper!
—
It must overlap the main brush at
the top and bottom
Insert the swept material
container
Checking and adjusting
sweeping area of the
sweeping roller
Cover a level surface evenly with
dust
Raise the sweeping machine on
the front and put it on the
prepared surface
Lock the hand brake
Run the main brush for
approx. 15-30 s
Raise the sweeping machine on
the front and move it to the side
The form of the sweeping pattern
forms a regular rectangle, that is
between 30 - 40 mm wide.
Note:
If the sweeping pattern is uneven it
can be corrected by readjusting the
sweeping pattern width!
