Kärcher KHP 4, Operation Instructions Manual

Page: 10 / 144

– 5
The scope of delivery of the device (depending on the
model) is illustrated on the packaging. These operating
instructions describe all possible options.
Illustrations on Page 2
1 Coupling element for water connection
2 Water connection with integrated sieve
3 Appliance switch „0/OFF“ / „I/ON“
4 High pressure hose
5 High-pressure hose drum
6 Storage for trigger gun
7 Transport handle
8 Hand crank for hose drum
9 Net for accessory compartment
10 Mains cable with mains plug
11 Detergent Tank
12 Bearing wheel
13 Trigger gun
14 Lock trigger gun
15 Key to detach the high pressure hose from the trig-
ger gun
16 Spray lance with Dirtblaster
For strong contaminations.
17 Spray lance with pressure regulation (Vario Power)
Carrying out the most common cleaning tasks.
The working pressure can be continuously in-
creased from "SOFT" to "HARD". To adjust the
working pressure, release the trigger gun lever and
turn the spray lance to the desired position.
Suitable for use with detergents.
Mount loose parts delivered with appliance prior to start-
up.
Illustrations on Page 3
Illustration
 Push the wheels into the intake.
 Secure the wheels using the included plug. Align
the plug properly!
Illustration
 Insert the transport handle and screw in.
Illustration
 Press the connecting fitting from the short high
pressure hose into the brass intake, secure with
clamps.
Note: Make sure the connection nipple is aligned
correctly.
Check the secure connection by pulling on the high
pressure hose.
Illustration
 Insert holder for trigger gun.
Illustration
 Screw the coupling element to the water connec-
tion on the appliance.
Illustration
 Push the high pressure hose into the trigger gun
until it locks audibly.
Note: Make sure the connection nipple is aligned
correctly.
 Check the secure connection by pulling on the high
pressure hose.
 Park the appliance on an even surface.
 Insert the mains plug into the socket.
For connection values, see type plate/technical data.
Observe regulations of water supplier.
ATTENTION
Impurities in the water can damage the high-pressure
pump and the accessories. For protection, the use of
the KÄRCHER water filter (optional accessory, order
no. 4.730-059) is recommended.
Illustration
 Attach the water supply hose to the coupling on the
water connection.
 Connect the water supply hose to the water supply.
 Completely open the water tap.
Description of the Appliance
Additionally required
Fabric-reinforced water hose with commercially
available coupling.
– Minimum diameter, 1/2 inches (13 mm).
– Minimum length 7.5 m.
Assembly
Start up
Water supply
10 EN