Kärcher K 6.450, Operating Instructions Manual

Page: 6 / 16

6 English
Î Illustrations on Page 12
Mount loose parts delivered with appliance
prior to start-up.
Illustration
Î Place the bottom holder into the recess-
es and push forward until it audibly
locks in.
Illustration
Î Insert the top holder and push down all
the way.
Illustration
Î
Install the top storage hook.
You will need the 2 included screws as well
as a Philips screwdriver PH 2.
Illustration
Î Insert both detergent hoses onto the
hose fittings.
Î Install the dosage regulator and con-
nect using 2 screws.
Illustration
Î Wind up the high-pressure hose on the
hose drum.
Illustration
Î Slide the free end of the coiled high
pressure hose through the recesses on
the dosage regulator.
Illustration
Î
Attach the transport handle, insert the
bolts into the bores and screw them in.
Illustration
Î Press the connecting fitting from the
short high pressure hose into the brass
intake until it locks into place audibly.
Check the secure connection by pulling
on the high pressure hose.
Illustration
Î Push the high pressure hose into the
trigger gun until it locks audibly.
Note: Make sure the connection nipple
is aligned correctly.
Check the secure connection by pulling
on the high pressure hose.
몇
Warning
According to the applicable regula-
tions, the appliance must never be
used on the drinking water supply
without a system separator. Use a
suitable system separator manufactured by
KÄRCHER; or, as an alternative, a system
separator as per EN 12729 Type BA. Water
flowing through a system separator is con-
sidered non-drinkable.
Caution
Always connect the system separator to
the water supply, never directly to the appli-
ance!
Note: Impurities in the water can damage
the high-pressure pump and accessories.
For protection, the use of the KÄRCHER
water filter (optional accessory, order no.
4.730-059) is recommended.
Observe regulations of water supplier.
For connection values, see type plate/tech-
nical data.
Î Use a fibre-reinforced water hose (not
included) with a standard coupling.
(Minimum diameter 1/2 inch (13 mm),
minimum length 7.5 m).
Illustration
Î
Screw the supplied coupling element to
the water connection on the appliance.
Push the water supply hose onto the
coupling unit, then connect it to the wa-
ter supply.
KÄRCHER recommends using the suction
hose accessory (sold separately) Order no.
9.505-779.0.
STEP 1:
Î Connect the suction hose to the water
inlet on the pressure cleaner and drop
the other end into a bucket.
Operation
Before Startup
Install the storage for hand-spray gun
Install the storage hook for the mains
connection cable
Install the dosage regulator for detergent
Install the transport handle
Connect the high pressure hose to the
hand spray gun
Water supply
Water supply from mains
How to draw water from a bucket when
using a KÄRCHER Pressure Cleaner