Kärcher K 4.84 MD, Manual

Page: 13 / 196

English
13
According to the applicable regula-
tions, the appliance must never be
used on the drinking water supply
without a system separator. Use a
suitable system separator manufactured by
Kärcher; or, as an alternative, a system
separator as per EN 12729 Type BA.
Note: Impurities in the water can damage
the high-pressure pump and accessories.
For protection, the use of the Kärcher water
filter (optional accessory, order no. 4.730-
059) is recommended.
Observe regulations of water supplier.
For connection values, see type plate/tech-
nical data.
Î Use a fibre-reinforced water hose (not
included) with a standard coupling.
(Minimum diameter 1/2 inch (13 mm),
minimum length 7.5 m).
Illustration
Î Screw the coupling unit (supplied) to the
water connection on the appliance.
Î Push the water supply hose onto the
coupling unit, then connect it to the wa-
ter supply.
This high-pressure cleaner is suited to work
with the Kärcher suction hose with backflow
valve (Optional accessory, order no. 4.440-
238) to draw in surface water, e.g. from wa-
ter butts or ponds (see specifications for
max. suction height).
Î Fill the Kärcher suction hose with back-
flow valve with water, screw to water
supply and hang into he water butt.
Î Separate the high pressure hose from
the high pressure connection point of
the appliance.
Î Switch the appliance on "I/ON" and op-
erate until the water exits the high-pres-
sure connection without bubbles.
Î Turn off the appliance "0/OFF".
Caution
Never operate the high-pressure cleaner
when the tap is turned off as dry running will
damage the high-pressure pump.
Illustration
Î Connect the high pressure hose to the
high pressure connection of the appli-
ance.
Illustration
Î Push the spray lance into the trigger
gun and fasten it by turning it through
90°.
Î Completely open the water tap.
Î Insert the mains plug into the socket.
Î Turn on the appliance “I/ON”.
몇
Danger
The trigger gun is subjected to a recoil force
when the water jet is discharged. Make
sure that you have a firm footing and are
also holding the trigger gun and spray lance
firmly.
Î Unlock the lever on the trigger gun.
Î Pull on the lever of the trigger gun; the
device will switch on.
Note: Release the lever of the trigger gun;
the device will switch off again. High pres-
sure remains in the system.
Carrying out the most common cleaning
tasks. The work pressure can be stageless-
ly regulated between "Min" and "Max".
Î Release the lever on the trigger gun.
Î Turn the spray lance to the desired po-
sition.
For particularly dirty items or areas.
Not suitable for use with detergents.
Suitable for use with detergents.
Water supply
Water supply from mains
Drawing in water from open reservoirs
Start up
Operation
Spray lance with pressure regulation
Spray lance with dirt blaster
Washing brush