Kärcher ICC 1 S D, Service Manual

Page: 41 / 71

41
ICC 1 S D Basic Settings and Service Procedures
Running Gear – Wheel change / Steering wheel
Changing front wheel
– Secure unit to prevent rolling, and loosen
wheel bolts.
– Place hydraulic jack under front axle near
wheel to be changed, and jack up unit.
– Support unit with block.
– Change wheel, tighten wheel nuts, then
torque to finish (refer to Specifications for
torque rating).
Changing rear wheel
– Secure unit to prevent rolling, and loosen
wheel bolts.
– Insert round steel bar (20 mm dia.) into rear
jacking eye.
– Place hydraulic jack under protruding round
bar, and jack up unit.
– Support unit with block.
– Change wheel, tighten wheel nuts, then torque
to finish (refer to Specifications for torque
rating).
Note:
Round steel bar must be cradled in jack
head notch.
Jacking eye at rear
Front axle jacking point
Removing steering wheel
– Pull center cap off steering wheel (1).
– Remove center nut from steering shaft.
– Install suitable pulling tool using tapped holes
(2).
– Pull off steering wheel.
Removing steering wheel
1 Steering wheel
2 Tapped holes (2x)