![background image](http://html1.mh-extra.com/html/karcher/hds-6-10-c/hds-6-10-c_manual_4234452035.webp)
– 11
Figure 14
Exchange the poles at the appliance
plug.
– No line voltage, see "Appliance is not
running".
– Lack of oil
Replenish oil.
– Water shortage
Check water supply, check connec-
tions.
– Leak in the high pressure system
Check high pressure system and con-
nections for tightness.
– Fault in the voltage supply or current
pickup of the motor too high.
Check main connections and mains
fuse.
Inform Customer Service.
– Engine overload/overheat
Set the appliance switch to "0/OFF“.
Allow device to cool down.
Turn on the appliance.
– Error occurs repeatedly.
Inform Customer Service.
– The exhaust temperature limiter has
been triggered.
Set the appliance switch to "0/OFF“.
Allow device to cool down.
Turn on the appliance.
– Error occurs repeatedly.
Inform Customer Service.
– Obstructed reed switch in the lack of
water fuse or magnetic piston stuck.
Inform Customer Service.
– The flame sensor turned the burner off.
Inform Customer Service.
– Fuel tank empty.
Refill fuel.
– System care bottle empty.
Replace the system care bottle.
– Detergent tank is empty.
Refill detergent.
– No power
Check power connection/conduit.
– Air within the system
Vent pump:
Set dosing value for detergent to "0".
With open hand spray gun turn device
on and off multiple times with the device
switch.
Open and close the pressure/quantity
regulation at the pump unit with the
hand spray gun open.
Note:
By dismantling the high pressure
hose from the high pressure connection the
venting process is accelerated.
If detergent tank is empty, refill.
Check connections and conduits.
– Pressure is set to MIN
Set pressure to MAX.
– Sieve in the water connection is dirty
Clean sieve.
Clean the fine filter; replace it, if neces-
sary.
– Amount of water supply is too low.
Check water supply level (refer to tech-
nical data).
Indicator lamp for rotation direction
will blink (3-phase appliances only)
Indicator lamp "Ready for use"
turns off
Indicator lamp service
Indicator lamp service will be
illuminated
1x blinking
2x blinking
3x blinking
4x blinking
5 x blink
6 x blink
Fuel indicator lamp glows
Indicator lamp system care is
illuminated
Indicator lamp for detergent glows
Appliance is not running
Device is not building up pressure
35
EN
Summary of Contents for HDS 6/10 C
