Connection values, see technical data.
Connect the supply hose (recomm.
width 5-10 m, min. diameter 1/2”) to the
device’s water connection and to the
water supply (such as to the tap).
Note
The water supply hose is not included in
the scope of delivery.
Open the water supply.
15
Danger
Risk of explosion
Do not spray any flammable liquids. When
using the device in areas with explosion
risk (such as gas stations), the relevant
safety regulations must be followed.
Attention
Clean motors only in areas with the
respective oil separator
(environmental protection).
Risk of clogging. Only place the nozzles
in the accessory compartment with the
nozzle outlet facing upward.
Note
The device is equipped with a pressure
switch. The motor only starts when the gun
trigger has been pulled.
Unlock the manual spray gun and
remove the gun’s lever.
Set the main switch to “I” position.
Management
Working with high pressure
Turn off the manual spray gun.
Choose the desired nozzle:
Selecting the jet type
High-pressure flat jet (25º)
for large surfaces.
Golden
Nozzle
Silver
Nozzle
Low-pressure flat jet
(CHEM) for operating with
detergents or cleaning with
lower pressure.
Put the desired nozzle on the threaded
coupling and screw it onto the
spray lance.
Warning
Any unsuitable detergents could damage
the device and the object to be washed.
Only use detergents that have been
authorized by Kärcher. Keep the
recommended dosage in mind and the
detergent recommendations. Use
detergents in moderation so as not to
harm the environment.
Keep the safety recommendations for
detergents in mind.
Kärcher detergents ensure
malfunction-free operation.
Request assistance in a timely manner or
request our catalog or our detergent
information sheet.
Pull out the detergent suction hose.
Hang the detergent hose in a container
containing a detergent solution.
Fit the golden nozzle
Set the detergent dispensing valve to
the desired concentration.
Spritz the dry surface with detergent
and let it work but do not let it dry.
Direct the high-pressure water jet at the
dissolved dirt to remove it.
After operation, place the filter in clean
water. Turn the dispensing valve to the
maximum detergent concentration.
Start the machine and rinse for
one minute.
By releasing the manual spray gun
lever, the machine shuts off.
By pressing the manual spray gun lever
again, the machine comes on again.
Working with detergent
Recommended cleaning method
Interrupting operation
