– 6
vices marked with this symbol must not
be disposed of with regular household
rubbish.
Notes about the ingredients
(REACH)
You will find current information about
the ingredients at:
www.kaercher.com/REACH
–
Check the contents of the pack be-
fore unpacking.
–
In case of transport damage inform
vendor immediately.
Read the oil level display when the
device is not running. The oil level
must be above the two pointers.
Unscrew the fastening screws of
the device hood; remove the device
hood.
Cut off tip of oil container cover
Fasten the device hood.
Note:
The EASY!Lock system joins
components with a quick-fasten thread
solidly and securely with just one turn.
Insert the high pressure nozzle onto
the spray lance.
Install union nut and hand-tighten it
(EASY!Lock).
Join the spray lance with the trigger
gun and tighten until hand-tight
(EASY!Lock).
Join the high-pressure hose with
trigger gun and high-pressure con-
nection of the appliance and tighten
until hand-tight (EASY!Lock).
Lock in the cable hook in the side-
hole on the handle.
몇
WARNING
Risk of injury! Appliance, accessories,
supply lines and connections must be
in fault-free condition. If they are not in
a perfect state then the appliance must
not be used.
몇
DANGER
Danger of injury by electric shock.
–
It is imperative to connect the appli-
ance to the electric mains by means
of a plug. It is forbidden to perma-
nently connect the appliance to the
power supply. The plug serves for
the disconnection from the mains.
–
The appliance may only be con-
nected to alternating current.
–
Minimum fuse strength of the sock-
et (see Technical Data).
–
The highest allowed net impedance
at the electrical connection point
(refer to technical data) is not to be
exceeded. In case of confusion re-
garding the power impedance pre-
sent on your connection, please
contact your utilities provider.
–
Use the extension cord that has an
adequate cross-section (see "Tech-
Before Startup
Unpacking
Check oil level
Activate deaeration of oil
container
Install hand spray gun, spray
lance and nozzle
2.
1.
Start up
Electrical connection
8
EN
