3. Open water source.
4. Squeeze trigger to purge.
Note: Releasing the pressure inside the
gun and hose will help start the
engine.
5. Start the Engine.
Always relieve spray gun pressure
before pulling starter cord. Pull starter
cord slowly until resistance is felt, then
pull rapidly.
► STEP 1: Turn the engine switch to
"ON" position.
► STEP 2: Move choke lever to
"COLD START
"
position.
► STEP 3: Turn the fuel valve to "ON"
position.
► STEP 4: Put the throttle lever to the
"FAST" position.
► STEP 5: Pull trigger on spray gun to
release pressure.
► STEP 6: Locate recoil cord and pull
slowly until resistance is felt. At this
point, pull rapidly to start engine.
► STEP 7: After the engine has started,
turn the choke lever to "RUN" position.
NOTE: If unable to start the engine,
repeat the above operation one or two
times.
NOTE: If the temperature is higher,
such as during summer or if the engine
is hot, choke valve should be switched
to "RUN" position before starting.
Cleaning Procedure:
Position the tip of the wand 15-20 cm
(6”-8”) away from the surface to clean
at a 45°angle.
Starter cord rapid retraction can result
in Serious injury. Rapid retraction will
pull hand and arm towards engine
faster than you can let go.
Page 14
Summary of Contents for G 3800
Page 1: ...G 3800 G3800 Petrol Pressure Washer 9 507 268 0...
Page 2: ...Page 2 Machine Part List...
Page 25: ......
Page 28: ......