CWP 2000
English
5.959-373 A 2006471 (06/03)
Operating Instructions
Positioning lights
The positioning lights serve three separate functions:
n
Prior to washing, they assist in positioning the vehicle.
n
After washing has been completed, they indicate the
direction in which the vehicle must exit the wash bay.
n
In the case of a malfunction, they flash rapidly to
indicate that a fault condition exists in the system.
Frost protection feature
When there is a risk of frost, water is blown out of the
pipe system. The washing unit can be fitted with two
different frost protection features:
n
Manual frost protection: The blowing-out operation is
initiated by the system operator.
n
Automatic frost protection: the blowing-out operation is
controlled by a thermostat.
Wheel deflector
The purpose of the wheel deflectors is to centre the vehicle
between the gantry tracks. Particularly in the case of
inexperienced drivers, the wheel deflectors prevent
inadvertent off-centre positioning of their vehicles.
Retrofit kit - anti-tipping safeguard
Even during bad handling by the customer, the system
stays on the guide tracks.
“On-board” compressor
If no compressor is available at the site of installation,
the ”on-board” compressor can be installed in the
system. Compressed air is required for:
n
hoisting of roof brush and roof dryer
n
delivery of the side brushes
n
delivery of the wheel-wash system (option)
n
drive unit of the metering pumps
n
frost protection facility (option)
The compressor is located in the lower part of pillar 1.
A6
A General system description
