CLEANING PROCEDURE
BRC 46/38 C 86306850 12/27/07
3-8
Push down on handle to raise vacuum
shoe and brush before moving to the next
cleaning pass. Overlap brush contact
area approximately 1inch.
During operation, observe the following: The
FB10 is equipped with clear internal covers to
facilitate operator viewing of dirty solution and
vacuum air flow.
During operation, observe the vacuum intake
cover. Large amounts of water or foam entering
the vacuum system can damage the vacuum
motor. If you notice either condition,
shut down
the machine immediately
. Empty recovery
tank and/or add defoamer to recovery tank.
STEP
2
STEP
3
STEP
4
Start at wall closest to power outlet. Pull
straight back without pushing down on
handle.
STEP
1
1ft.
(30cm)
OFF
Release intermittent setting or turn off
continuous setting on brush/spray switch
approximately 1 foot before ending
cleaning pass.
1in.
(25mm)
VACUUM
INTAKE COVER
SOLUTION
INTAKE COVER
