background image

     - 

8

Danger

Danger of explosion. Do not put tools or 
similar on the battery, i.e. on the terminal 
poles and cell connectors.
Risk of injury. Ensure that wounds never come 
into contact with lead. Always clean your hands 
after having worked with batteries.

* Appliance requires 2 batteries

1) 

Complete set (24 V/105 Ah) incl. connect-

ing cable, order no. 4.035-449.0

2) 

Complete set (24 V/70 Ah) incl. connect-

ing cable, order no. 4.035-447.0

3) 

Complete set (24 V/80 Ah) incl. connect-

ing cable, order no. 4.035-450.0

Push the appliance forward about 2 m 
so that the steering rollers point toward 
the rear.

Lower the cleaning head.

Empty the fresh and dirt water reser-
voirs.

Loosen the tank lock and tilt the tank 
upwards. 

Place the batteries in the tray close to 
each other towards the cleaning head 
and fasten them to the floor using the 
included holding blocks.

Caution

When the batteries are installed and re-
moved, the stability of the appliance can be 
compromised; ensure a safe stance.

Connect the connection cable to the 
free battery poles (+) and (-).

Connect pole using the enclosed con-
necting cable. 

Warning

Pay attention to correct poles.

Installation sketch for 2 batteries

Swivel the water reservoir all the way 
down, check the lock.

Note

Charge the batteries before commissioning 
the appliance.
See also "Charging the batteries".

Caution

Risk of damage due to tipping appliance; 
remove batteries only if the appliance is 
equipped with a cleaning head.

Remove the Intelligent Key.

Push the appliance forward about 2 m 
so that the steering rollers point toward 
the rear.

Lower the cleaning head.

Loosen the tank lock and tilt the tank 
upwards. 

Clamp off the minus pole of the battery.

Clamp off the remaining cables from the 
battery.

Remove the support blocks or the foam 
pieces.

Remove the batteries.

Caution

When the batteries are installed and re-
moved, the stability of the appliance can be 
compromised; ensure a safe stance.

Dispose of the used batteries according 
to the local provisions.

To ensure a reliable operation of the appli-
ance maintenance contracts can be con-
cluded with the competent Kärcher sales 
office.

In case of danger of frost:

Empty the fresh and dirt water reser-
voirs.

Store the appliance in a frost-protected 
room.

Recommended batteries, B 40

Order No.

Description

6.654-141.0

1)

105 Ah - mainte-
nance-free

12 V*

6.654-093.0

2)

70 Ah - maintenance-
free

12 V*

6.654-097.0

3)

80 Ah, - low mainte-
nance

12 V*

Insert batteries and connect

Removing the batteries

Maintenance contract

Frost protection

10

EN

Summary of Contents for B 40 C Bp

















Reviews: