12
Starting
-Dirt in the feed water could lead to the
appliance being damaged. To avoid this
risk, we recommend fitting a filter with
3/4" connection .
-If you are using an extension cable, it
should always be completely unwound
from the cable drum and have a sufficient
cross-sectional area (10 m = 1,5 mm²,
30m = 2,5 mm²).
Operation with high pressure
-The appliance is equipped with a pressu-
re-operated switch. The motor starts only
if the lever of the gun is pulled.
-The safety ratchet does not lock the lever
of the gun during operation but only
prevents it from opening unintentionally.
Suction operation
-Allow the pump to operate without the
high-pressure hose until water appears at
the high-pressure outlet without any
more bubbles.Then re-attach the high-
pressure hose.
Operation with Detergent
-We recommend that you use detergent
sparingly for the sake of the environment.
Observe the recommended dosage on
the detergent label.
-This machine has been designed for use
with cleaning detergent supplied or re-
commended by the manufacturer. The
use of other cleaning detergents may af-
fect the operation of the machine and void
the warranty.
-We recommend the following cleaning
methods:
Step 1: Loosening dirt
Spray on detergent sparingly and allow
to react for a short time.
Step 2: Removing dirt
Spray off the loosened dirt with the
high-pressure spray.
Switching Off
-After using a detergent, the appliance
should be rinsed clear. To do this, sus-
pend the detergent suction hose in a con-
tainer of clean water, and run the pump for
approx. 1 minute.
-Pull the trigger until there is no more pres-
sure in the appliance, and secure the
trigger with the safety ratchet against
unintentional opening.
-Frost will destroy an appliance which has
not been completely emptied of water.
Troubleshooting
!Note: Disconnect the appliance from the
power mains before all repair work.
Appliance does not Work
-Check whether the voltage shown on the
rating plate corresponds to that of the
power source.
-Check the connector cable for damage.
Appliance does not reach Pressure
-Set the spray lance to the maximum
working pressure.
-Vent the appliance.
-Clean the strainer in the water
connection.
-Check the inlet water flow rate.
-Check all inlet pipes to the pump for leaks
or block-age.
Strong Pressure Fluctuations
-Clean the high-pressure nozzle. Remove
dirt from the nozzle hole with a needle and
then rinse out with water from the front.
Pump Leaks
-3 drops per minute are permissible. In the
case of more serious leakage, you should
contact the authorized customer service.
No Detergent Suction
-Set the spray lance to the minimum
working pressure.
-Clean the detergent suction hose with fil-
ter, and check for leaks.
Spare Parts
-A selection of the most common spare
parts numbers is listed at the end of these
operating instructions.
General Information
Purpose
-Use the appliance to clean machines,
vehicles, buildings, tools etc.
-Clean facades, terrasses, garden equip-
ment etc. without detergent only with the
high-pressure spray.
-Engines may only be cleaned at locations
with appropriate oil separators (environ-
mental protection).
Safety Equipment
When the hand-held spary gun is closed,
the overflow valve switches off the
appliance via a pressure-operated switch.
The overflow valve is also a safety device
against exceeding the maximum allowable
working pressure.
KARCHER 2 YEAR WARRANTY
KARCHER CANADA INC. warrants to the
original owner that this product shall be
free from defects in material and workman-
ship for two years from the date of its ori-
ginal purchase. If such a defect appears
during the warranty period, upon presenta-
tion of proof of purchase, KARCHER CA-
NADA INC. will repair or replace (at its
option) your product without charge within
35 days of receipt.
This warranty does not cover accidental
damage, unreasonable use, normal wear
and tear, loss of use or other consequential
damages, nor does it cover repairs made
or attempted by unauthorized persons.
Please note that no returns will be accep-
ted without prior authorization from our
customer service department.
It is the owner’s responsibility to file claims
for damage caused by public transportati-
on carriers directly with the carrier concer-
ned.
Summary of Contents for 502 MS plus
