Kärcher 2.111-012.0, Original Instructions Manual

Page: 7 / 88

– 2
You need to use the matching high pres-
sure nozzles to ensure that your high pres-
sure cleaner works properly.
Note:
The required packets of nozzles have been
adjusted to suit the corresponding high
pressure cleaners and must therefore be
ordered separately.
Figure 1, see cover page
1 Nozzle size (example)
 Read the nozzle size from the type
plate of the high-pressure cleaner.
 Select the nozzle package that is suita-
ble for the high-pressure cleaner from
the following table.
Figure 2, see cover page
1 O ring
2 Rotation arm
3 Nozzle
4 Union joint
 Inser the O ring in the nut of the rotation
arm.
 Place the nozzle on it.
 Slightly fasten the nozzle with the Union
joint.
Note:
The exit jet must be directed parallel to the
rotation arm.
Figure 3, see cover page
 Adjust the wrench area of the nozzle
(width 10) so that it is parallel to the ro-
tation arm.
 Tighten the Union joint (width 22) using
a wrench.
 Repeat the process on the second rota-
tion arm.
Note:
Do not attach the nozzles for the surface
cleaner to the spray lance of the high-pres-
sure cleaner.
Figure 4, see cover page
1 Injector nozzle
2 Wrench
 Screw the injector nozzle into the injec-
tor using the wrench and tighten it fin-
gertight (8 Nm).
The wrench is included with the nozzle
set.
Figure 5, see cover page
 Connect the steel pipe of the high pres-
sure cleaner to the surface cleaner and
tighten it with a wrench (opening width
24).
몇
CAUTION
A strong wastewater jet will emerge from
the hose connection. Do not use the sur-
face cleaner without a hose.
 Grease the O-ring at the end of the
hose using the accompanying grease
prior to installation.
 Insert the accompanying hose at the
hose connection of the surface cleaner
and secure it by turning.
 Route the other end of the hose to a
drain and secure it by means of the ac-
companying hook-and-loop tape.
Note:
If possible, lay hose without any slopes.
Maximum delivery height of the waste wa-
ter is 1 m.
The free end of the hose can be attached
by means of the included Velcro tape (e.g.
on a drain grid).
If necessary, use extension hose (see "Ac-
cessories").
 Hold the hand spray gun and the spray
pipe firmly with both hands.
 Guide the surface cleaner so that it re-
mains close to the surface to be
cleaned.
Nozzles packet
Nozzle size
high-pres-
sure cleaner Nozzle pack-
age Nozzle size
nozzle pack-
age
034...035 2.642-430.0 2x10 + 15
036...040 2.642-431.0 2x10 + 20
041...045 2.642-432.0 2x11 + 23
046...050 2.642-433.0 2x12 + 26
051...080 2.642-982.0 2x20 + 40
Assemble nozzle packet
Floor cleaning
7 EN