![background image](http://html1.mh-extra.com/html/karcher/1-324-522-0/1-324-522-0_operating-instructions-manual_655376010.webp)
10
English
Illustrations on Page 15
Mount loose parts delivered with appliance prior to start-
up.
You will need the 2 included screws as well as a Philips
screwdriver PH 2.
Illustration
Secure the wheels using the included plug. Align
the plug properly!
Insert the cover and screw in.
Illustration
Insert base.
Insert the included dowels all the way into the
holes.
Secure the base with the enclosed screws.
Illustration
Hook in storage for spray lance.
Secure the storage for the spray lance by means of
two screws.
Illustration
Attach the transport handle.
Secure the transport handle by means of two
screws.
Illustration
Hook the net into the hooks shown in the illustra-
tion.
Before
initial
startup, the high-pressure
gun must be coupled to the high-pressure
cleaner.
Insert the mains plug into the socket.
Within one minute, simultaneously
press the + and - buttons on the high-
pressure gun.
Hold down the buttons until the entire
signal strength symbol flashes.
Once coupling is complete, all six pressure levels
will be displayed.
Note:
You can find a detailed description of the coupling
here:
https//www.kaercher.com/FCR
Park the appliance on an even surface.
Illustration
Completely wind off the high-pressure hose and
disentangle any loops and knots.
Put the disentangled high-pressure hose through
the hose guide from the back.
Illustration
Push the high pressure hose into the trigger gun
until it locks audibly.
Note:
Make sure the connection nipple is aligned
correctly.
Check the secure connection by pulling on the high
pressure hose.
Insert the mains plug into the socket.
For connection values, see type plate/technical data.
ATTENTION
Impurities in the water can damage the high-pressure
pump and the accessories. For protection, the use of
the KÄRCHER water filter (optional accessory, order
no. 4.730-059) is recommended.
Observe regulations of water supplier.
ATTENTION
Hose couplings made of metal with aquastop can dam-
age the pump! Please use plastic couplings or KÄRCH-
ER brass couplings.
Illustration
Screw the coupling element to the water connec-
tion on the appliance.
Attach the water supply hose to the coupling on the
water connection.
Connect the water supply hose to the water supply.
Completely open the water tap.
This high-pressure cleaner is suited to work with the
KÄRCHER suction hose with backflow valve (Optional
accessory, order no. 2.643-100) to draw in surface wa-
ter, e.g. from water butts or ponds (see specifications for
max. suction height).
Note:
With vacuuming operation, the coupling for the
water connection is not required.
Fill the suction hose with water.
Screw the suction hose into the water connection of
the appliance and insert it into the water source
(e.g. rainwater drum).
Bleed the device as follows prior to operation:
Turn on the appliance “I/ON”.
Unlock the lever of the trigger gun.
Push the lever of the trigger gun, the device will
switch on.
Using the +/- buttons, set the high-pressure gun to
detergent level 1.
Let the device run (max. 2 minutes) until the water
exits the trigger gun without bubbles.
Release the lever of the trigger gun.
Lock the lever of the trigger gun.
Assembly
Install wheels
Installing the base
Install storage for spray lance
Install the transport handle
Attach the net to the accessory compartment
Coupling of the high-pressure gun
Start up
Water supply
Water supply from mains
Drawing in water from open reservoirs