MINI REMOTE
2
INSTALLATION:
1.Refer to the wiring chart for
wiring connections.
3.When installing the unit, the
main power should run from the
battery, through a 20 amps fast
blow fuse, to a power switch or
relay; then into the receiver unit.
For best results connect the
receiver main power connections
to the auxiliary terminal of the
ignition switch, PTO switch, or
ignition relay. Use 18 gauge or
heavier wire.
4.All connections must be
properly insulated to protect
against shorts.
FCC REQUIREMENT: Any device
in which this module is installed
must include a label that is
clearly visible containing the
following:
“Contains Module FCC ID:P4U-
MNTA1”
This is a requirement for any
unit that contains this module
and must be done. No
exceptions can be made.
BEFORE APPLYING POWER:
1.Check power and ground
polarity.
2.Check wiring harness for
possible shorts before connecting
remote control to output devices
(i.e., valves, relays) by checking
each mating pin terminal.
3.Read the rest of this manual.
