10
Inclined Plane (Manual Mode)
The Rotary Laser can be set up to create a single or dual
directional inclined planed at ±5° from the horizontal plane. This
is very helpful for laying inclined concrete surfaces, ensuring run-
off from pathways, and laying water and sewage lines.
1. Set up the Rotary Laser approximately level; the instrument
can compensate for up to ±5° from the horizontal plane.
2. Press the On/Off button. The power indicator will light
up and the laser beam will blink. If the instrument is set
up outside the ±5° limit the manual indicator will blink and
rotation will not begin.
3. The Rotary Laser is ready for work when the laser beam
has stopped flashing. The instrument is now level and the
laser head will rotate at 600 rpm.
4. Press the Manual/Automatic button to change the Rotating
Laser to Manual Mode.
5. Verify that the Manual
Indicator is illuminated.
6. For X direction slope:
Position X axis parallel
to plane needing slope
setup. Press to raise
Y1 and lower Y2. Press to raise X2 and lower X1.
For Y direction slope:
Position Y axis parallel to plane needing slope setup.
Press to raise Y1 and lower Y2. Press to raise Y2 and
lower Y1.
