SkinGuard® Series
Owner’s Manual
PN 400901 Rev. C
ECO 18-0281
Page 34
6. Leave the mattress to dry in a cool, dry area for an hour before using or storing. If the mattress is not
used immediately, roll the mattress and insert it into a plastic bag and store it in a storage area.
7. After the cleaning operations are completed, remove and dispose of the rubber gloves appropriately.
Wash your hands thoroughly with antibacterial soap.
SKINGUARD® FLOAT CONVERTIBLE FOAM AIR MATTRESS (FAM)
:
Note: The SKINGUARD® FLOAT CONVERTIBLE FOAM AIR MATTRESSES have a Kevlar fire retardant
sleeve (sock) barrier inside the cover. Care should be taken if removing the cover for cleaning.
Before attempting to clean the mattress, remove the bedding from the mattress. The mattress cover (top sheet) can be
cleaned following the steps below.
1. Wear eye goggles and protective gloves before starting the cleaning procedure.
2. Follow steps 2 through 4 in control unit cleaning procedure above to prepare disinfectant solution.
3. Clean the top and bottom mattress cover using the prepared disinfectant solution and refer to step 4 of the above Air
Mattress cleaning instructions for washing instructions.
4. Wipe dry with a clean cloth and allow to air dry as needed
CARE AND STORAGE
1. When the control unit is not in use, turn off the unit, disconnect the power cord from the power source,
and wrap the cord around the control unit. Secure the control unit and the power cord in a plastic bag and
cable tie to keep the unit dust-free.
2. Roll the mattress and place it in a plastic bag and tie wrap the bag. Cover and store the Foam Air
mattress in a flat position.
3. Store the control unit and the mattress in a storage area designated for medical electronic product
storage.
