①
⑩
②
⑪
③
⑫
④
⑬
⑤
⑭
⑥
⑮
⑦
⑯
⑧
⑰
⑨
⑱
⑲
6. Name of every part
Control panel (All machine type community)
⑫
⑪
⑬
⑦
⑭
⑧
⑨
②
⑩
①
④
⑤
③
⑥
⑮
⑯
⑲
⑱
⑰
STOP switch
TIMER display
This is the stop switch of blow operation and hot-air operation,
and for the cancellation of timer operation.
Setting time of the timer is displayed. Time is reduced by time
counting.
HOT-AIR switch
HEATER lamp
Hot-air operation is started when the switch was pushed.
ON/OFF of the heater is displayed by illumination and
flickering.
BLOW switch
Blow operation is started when the switch was pushed.
TEMP. ALM lamp
OPERATION BY TIMER switch
This is lighted within the range of the temp. alarm setting value
in the case that temp. alarm setting is input.
Time that the operation is started is set up when the switch was
pushed. Please push HOT-AIR switch after setting.
EXT. CNTL lamp
STOP BY TIMER switch
This is lighted when the operation condition was changed to
the external control.
Time that the operation is stopped is set up when the switch
was pushed. Please push HOT-AIR switch after setting.
EXT. SENSOR lamp
EXT. RUN switch
This is lighted when the operation condition was changed to
the external sensor.
Hot-air generator is operated with the external operation
signal and external heater ON/OFF signal by the switch is
continued to push (about 2 seconds).
OVERHEAT lamp
This is lighted and the breaker (NFB) is become trip in the
case that the heater case inside became a abnormal high temp.
HOT-AIR TEMP. display
Outlet temp. is displayed. Temp. of the external sensor is
displayed by the operation condition is changed to the
external sensor.
TEMP. WARN. Lamp
Breaker (NFB) is become trip or bloe operation is become in
the case that discharge temp. became a high temp. or suction
temp. became over the permission temp. of the blower.
SETTING TEMP. display
Setting temp. of the outlet is displayed. Setting temp. of the
external sensor is displayed by the operation condition is
changed to the external sensor.
BLOWER WARN. Lamp
This is lighted when the blower became the overload and
operation stops.
AIR VOL. COTL display
PUSH TO TEST
Setting value of the air volume control (Frequency setting) is
displayed.
Breaker (NFB) is become trip by the button is pushed.
MODE switch
This is used in the case that the operation condition is changed.
－４－
