6. Data Output
20
(4)
As you insert the leading edge of the roll paper,
the roller will automatically rotate to reel in the
paper and the paper comes out from the top.
*
If the paper is not set properly (the paper is
placed diagonally or bent), pull the head lever
up, remove the paper and repeat the above
procedure from (2) to (4).
(5)
Press
key to feed the paper until the
length of the paper coming out from the roller
reaches approximately 5cm.
* Make sure that the paper which just comes out
from the roller will not be caught in the roller
again.
(7)
Install the roll paper into the holder as
tightening the roll. Close the printer cover
making sure that the paper comes out of the
paper ejection located on the printer cover.
*
Be sure to eliminate any slack on the roll paper
as much as possible. Otherwise, the loose
portion may accidentally get pulled into the
roller.
Head Lever
Roll Paper
Holder
Approx. 5cm
(6)
Insert the provided core into the roll paper in
order to remove any slack from the roll paper.
*
This procedure prevents the roll paper to be
caught in the printer header when the roll paper
runs short.
Core
Roll Paper
Paper Ejection
Leading Edge of Roll Paper
