Kanmed Babybed, User Manual

Page: 9 / 12

User Manual BB1/070/1
Page 9 of 12
10 Spare parts/Accessories
700-0717 Silicon corner/handle Ordered by the piece
BB-20 Foam mattress For BB-1 and BB-3. Foam mattress, sealed, easy to
clean 650 x 440 x 40 mm
BB-21 Tent for BB-1 Please check with your local supplier or on the KANMED
homepage www.KANMED.se
for colours available
NOTE: Other accessories may be available. Please check with your local supplier or on the KANMED
homepage www.kanmed.se
Please contact your supplier for a price list.
11 EMC guidelines
Guidance and manufacturer’s declaration – electromagnetic emissions
The Babybed is intended for use in the electromagnetic environment specified below. The customer or the user of the Babybed
should assure that it is used in such an environment.
Emissions test Compliance Electromagnetic environment - guidance
RF emissions
CISPR 11
Group 1 The Babybed uses RF energy only for its
internal function. Therefore, its RF emissions
are very low and are not likely to cause any
interference in nearby electronic equipment.
RF emissions
CISPR 11
Class B
Harmonic emissions
IEC 61000-3-2
Class A
Voltage fluctuations/ flicker emissions
IEC 61000-3-3
Complies
The Babybed is suitable for use in all
establishments including domestic
establishments and those directly connected to
the public low-voltage power supply network
that supplies buildings used for domestic
purposes.
Guidance and manufacturer’s declaration – electromagnetic immunity
The Babybed is intended for use in the electromagnetic environment specified below. The customer or the user of the Babybed
should assure that it is used in such an environment.
Immunity test IEC 60601 test level Compliance level Electromagnetic environment -
guidance
Electrostatic discharge
(ESD)
IEC 61000-4-2
+/- 6 kV contact
+/- 8 kV air
+/- 6 kV contact
+/- 8 kV air
Floors should be wood, concrete or
ceramic tile.
If floors are covered with synthetic
material,
the relative humidity should be at
least 30 %.
Electrical fast transient /
Burst
IEC 61000-4-4
+/- 2 kV for power supply
lines
+/- 1 kV for input/output
lines
+/- 2 kV for power supply
lines
n/a. for input/output lines
Mains power quality should be that of
a typical commercial or hospital
environment.
Part no Description Remark
700-0723 Side wall left/right 19 cm height.
700-0721 Side wall front 19 cm height.
700-0722 Side wall rear 19 cm height, Grooves for tubing
700-0728 Side wall left/right 24 cm height.
700-0729 Side wall front 24 cm height.
700-0730 Side wall rear 24 cm height. Grooves for tubing
700-0727 Tent Pole