42
6.2 advanced Setup
6.2.1 Set Password
The Set Password option allows you to enable a 4-digit password for the Setup menus, protecting the
system against unauthorized setting changes.
To set a password:
1. Tap the
‘ENT’ button
. The digit furthest to the left will start blinking, indicating that it is
currently selected. Tap the
UP/DoWN buttons
to increase/decrease the digit by one.
2. Tap the
‘ENT’ button
to select the next digit to the right. Tap the
UP/DoWN buttons
to
increase/decrease the digit by one.
3. Repeat step 2 until you have entered your password, then press and hold the
‘ENT’ button
to
set your password.
Once your password is set, the user will be prompted to enter the password whenever they try to enter
the Setup Selection menu.
Enter the password as “0000” to disable password protection.
6.2.2 Set Error retry Count
The Set Error Retry Count option allows you to configure the number of times that the duplicator
retries sending general error handling commands when it encounters an error before failing.
The number of error retries can be set from 0 to 9 times. The default setting is 1.
Tap the
‘ENT’ button
and then press the
UP/DoWN buttons
to change this option’s setting.
Tap the
‘ENT’ button
to set the Error Retry Count.
6.2.3 Set Command retry Count
The Set Command Retry Count option allows you to configure the number of times that the duplicator
retries sending general ATA commands to the SATA port before failing.
The number of retries can be set from 0 to 9 times. The default setting is 1.
Tap the
‘ENT’ button
and then press the
UP/DoWN buttons
to change this option’s setting.
Tap the
‘ENT’ button
to set the Command Retry Count.
The Setup Menus
