40
6.1.28 Skip read Error
The Skip Read Error option allows you to enable or disable error skipping during Disk, SMART,
Brief and Resize modes.
Tap the
‘ENT’ button
to change this option.
•
[ ]
– Disabled (default). When an error is detected while reading from the Source, the duplicator
process will fail out.
•
[
٭
]
– Enabled. When an error is detected while reading from the Source, the duplicator will
skip the bad sector on the Source and fill the sector with zeroes on the Target.
6.1.29 No button Sound
The No Button Sound option allows you to enable or disable the audible tone that sounds when you
tap or hold a button.
Tap the
‘ENT’ button
to change this option.
•
[
٭
]
– Button sounds are disabled. No audible tones will sound when you tap or hold a button.
•
[ ]
– Button sounds are enabled (default). Tapping a button will be accompanied by a short
tone. Holding a button will sound a low tone followed immediately by a higher pitched tone.
6.1.30 Keep LED result
The Keep LED Result option allows you to configure whether the LED status lights remain on after
a duplication completes.
•
[
٭
]
– LED Status lights from the previous duplication will remain on until the next duplication
process is started.
•
[ ]
– LED Status lights reset after duplication completes (default). After the duplication
completes and you exit from the completion screen, the LEDs will reset.
The Setup Menus
