Kangaroo Hillcrest ABX, Manual

Page: 58 / 74

Troubleshooting
Symptom Problem Solutions
My Remote Guidance System does
not function. All connections are
made properly and the Confirm
Command indicator light
flashes normally.
1. Circuit board needs to be reset.
2. Water or debris could be inside
connection plugs.
1. Turn the Function Switch OFF –
wait 5 seconds.
2. Clean and dry all male plugs and
female connectors.
My Remote Guidance System does
not function. All connections are
made properly but the Confirm
Command indicator does not flash.
9 volt battery connector inside the
Remote Transmitter may be loose. Using pliers, carefully tighten
Remote Transmitter battery metal
connection snap, then reconnect
the battery.
Intermittent and erratic operation.
My X-Series shuts off, loss of
steering directional control,
or will not restart. Outside interference. By FCC regulation, Remote
Guidance System must accept all
outside interference. See label on
the Remote Receiver.
My Remote Guidance stops
unexpectedly and will not
restart right away. Grass or debris in the male plugs
and female connectors. Clean and dry all male plugs and
female connectors.