3x1 Wall plate Extender & Switcher with HDMI 2.0 and USB-C
8
5. Button Control
5.1
Source Switching
1)
Press the
SOURCE AUTO
button to switch to next source device, and then the
corresponding input LED will turn green.
2)
Press and hold the
SOURCE AUTO
button at least 3 seconds to enable auto
switching mode, and it abides by the following principles:
⚫
The switcher will switch to the first available active input starting at HDMI IN 1>
HDMI IN 2 > USB-C.
⚫
New input: Once a new input signal detected, the switcher will automatically
switch to this new signal.
⚫
Source removed: When an active source is removed, the switcher will switch to
the first available active input starting at HDMI IN 1.
⚫
Reboot: The switcher can save the last configuration before losing power. If the
last switching mode is auto switching, the switcher will automatically enter auto
switching mode once rebooted, then detect all inputs and memorize their
connection status for future rebooting using. If the last selected input source is
still available, the switcher will switch to this input. Otherwise, it will switch to the
first available active input source starting at HDMI IN 1.
⚫
Exit auto switching mode: Press and hold the SOURCE (AUTO) button for 3
seconds again to exit the auto mode, and the input source will not be changed.
5.2
Display Control
1)
Press the
DISPLAY ON/OFF
button to turn on/off the display which supports CEC.
2)
The
DISPLAY ON/OFF
button also can be programed by IR learning feature or
RS232 command. For more details, please refer to the
on
the page 15.
