3x1 Wall plate Extender & Switcher with HDMI 2.0 and USB-C
16
7. Button User-defined
Press the
DISPLAY ON/OFF
button can turn on/off the display. If the incompatible
display device needs to be used, the
DISPLAY ON/OFF
button can be programed by
IR learning feature or RS232 command.
⚫
IR learning feature:
Please according the below IR learning steps to define the
DISPLAY ON/OFF
button.
1)
Press and hold the
DISPLAY ON/OFF
button for five seconds until the
SOURCE
AUTO
button LED flash to enable the IR learning mode.
2)
Press the
DISPLAY ON/OFF
button to choose the ON or OFF IR command be set:
✓
Button LED lighting indicates that
DISPLAY ON
mode is selected.
✓
Button LED flashing indicates that
DISPLAY OFF
mode is selected.
3)
Point the IR remote at the IR sensor and press the respective button on the IR
remote.
4)
The
SOURCE AUTO
and
DISPLAY ON/OFF
button LEDs will keep lit for 3 second
to indicate that IR command has been learnt, and then these two button LEDs will
go out to exit the IR learning mode.
Note: The IR learning function will self-terminate after 30 seconds due to inactivity
