6
optional IP Master (EXT-PROCTRL) Controller/control software)
• Bi-directional IR, RS-232, USB 2.0, and Ethernet extension
• Supports a special Simultaneous Mode for USB extension allowing
• a host connected to a single transceiver to connect to up to 7 transceivers with USB devices
connected (mass storage devices are not supported in this mode)
• Unit can be powered directly by PoE when connected to a 10 Gigabit Ethernet (10GbE)
switch that provides PoE (802.3at)
• Basic configuration via front panel buttons with an On-Screen
• Display (OSD)
• Supports the use of an external control center (IP Master (EXT-PROCTRL) Controller) or
control software to provide expanded functionality (Contact your authorized dealer for
more information)
6. OPERATION CONTROLS AND FUNCTIONS
6.1 Front Panel
1. POWER LED:
This LED will illuminate to indicate the unit is on and receiving power.
2. T/R LED:
This LED indicates if the unit is in Transmitter (Green LED) or Receiver (Amber
LED) mode.
3. SOURCE LED:
This LED will illuminate when the local HDMI input is live and selected.
4. USB 2.0 (Type A) Ports:
Connect directly to standard USB devices such as a mouse,
keyboard or flash drive to extend their USB functionality to the currently active/routed
USB Device Mode transceiver.
5. STATUS LED BLOCK
A. GbE LED:
This LED will illuminate and blink to indicate a live and active connection on
the gigabit Ethernet port.
B. VIDEO LED:
This LED will illuminate when a video signal is live on the 10GbE
streaming port. When no video is active the LED will remain off, even if the streaming
connection is valid.
C. TX & RX LINK LEDs:
These LEDs will illuminate and blink to indicate data
transmission and reception activity across the 10GbE streaming connection.
D. USB LED:
This LED will illuminate when the unit’s USB ports have successfully paired
with the USB ports on another unit. This LED will blink if the unit’s USB ports are not
currently paired and in stand-by mode.
6. MENU BUTTON:
Press to enter the OSD menu, or to back out from menu items.
